V812 Series
General Spesifications
| V812xS | V812xSD | ||
| Power supply | Rated voltage | 100-240V AC | 24V DC |
| Permissible range of voltage | 100-240V AC±10% | 24V DC±10% | |
| Permissible momentary power failure | Within 20ms | Within 1ms | |
| Demand (maximum rating) | 70VA or less | 30W or less | |
| Inrush current | 20A, 10ms (100V AC) | 20A, 2ms | |
| 40A, 10ms (200V AC) | |||
| Insulation resistance | 500V DC, 10M? or more | ||
| Physical environment | Operation ambient temperature | 0°C – +50°C | |
| Storage ambient temperature | -10°C – +60°C | ||
| Operation ambient humidity | 85%RH or less (without dew condensation, Max. wet bulb temperature: 39°C or lower) *1 | ||
| Resistance to solvent | No attachment of cutting oil or organic solvent | ||
| Atmosphere | Not exposed to corrosive gas or conductive dust | ||
| Operation altitude | 2,000 meter or lower | ||
| Contamination level *2 | Level 2 | ||
| Mechanical | Resistance to oscillation | Vibration frequency: 10–150Hz, acceleration: 9.8m/s2(1.0G) pulsating width: 0.075mm, X,Y,Z: 3 directions 1 hour each way | |
| Resistance to shock | Pulse shape: half-sine, peak acceleration: 147m/s2(15G), X,Y,Z: 3 directions, six times each way | ||
| Electric | Noise proof | 1500Vp-p (pulse width 1 s, pulse rise time : 1ns) | |
| Static discharge | Complies with IEC61000-4-2, contact: 6kV, air: 8kV | ||
| Installation conditions | Grounding | Grounding resistance : Less than 100 ?, FG/SG separation | |
| Structure | Protect structure: Front panel: Compatible with IP65 (when water-proof gasket is used.) Rear cover: Compatible with IP20 Form: Single unit Installation method: Panel mounting |
||
| Cooling system | Natural air cooling | ||
| Weight | Approx.2.9kg | ||
| Dimensions W×H×D(mm) | 326.4×259.6×69.0 | ||
| Panel cutout (mm) | 313.0×246.2 (+0.5/-0) | ||
| Case color | Gray | ||
| Material | PC/ABS | ||
*1 Keep wet bulb temperature under 39 to avoid an accident.
*2 Contamination level is an index that shows the incidence rate of conductive substance. At Level 2, only nonconductive substance is produced, but a temporary conductive state may occur due to dew concentration.
Interfaces
Dimensions
Side view |
Front view |
Rear view |
Bottom view |
Panel cutout |
| 1. Display 2. Power lamp 3. Function switch 4. Connector for communication unit (CN5) 5. Connector for optional unit (CN7) 6. Battery holder 7. CF card slot (CF) 8. Dip switch 9. Power supply |
10. Modular 8-pin for serial port (MJ1) 11. Modular 8-pin for serial port (MJ2) 12. D-Sub9-pin for serial port (CN1) 13. 100BASE-TX/10BASE-T port (LAN) 14. USB-B (slave) 15. USB-A (master) 16. Screw port for fixing USB cable lock |